View previous topic :: View next topic |
Author |
Message |
carlmartin
Joined: 13 Aug 1999 Posts: 2
|
Posted: Mon Sep 25, 2000 8:13 am Post subject: Board Repair |
|
|
I broke the tip on my Mistral Flow and need some advise.
The tip buckled about ten inches from the end. The top of the board is fine but the bottom is charcked with a buckle al the way across.
I have done intensive fiberglass work on other boards but can I use epoxy on the Flow?
Do I use marine epoxy or 10 minute light duty epoxy or is there some magic goop that will work better?
I guess I can take to the board repair shop but I would like to know the answer anyway. |
|
Back to top |
|
|
spyder
Joined: 24 Sep 1996 Posts: 2790 Location: oahu
|
Posted: Mon Sep 25, 2000 8:13 pm Post subject: RE: Board Repair |
|
|
carl -
Here is a good website I found that lists references and has a bunch of repair info.
http://www.viser.net/~anthwind/
hope that helps. |
|
Back to top |
|
|
joeyyyy
Joined: 18 Jul 2000 Posts: 162
|
Posted: Sat Sep 30, 2000 1:26 am Post subject: RE: Board Repair |
|
|
I think you might have a defective board.
I read many complaints on mistral here on this site. check them out...
there are many in the venting and gear forums.. |
|
Back to top |
|
|
|
|
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum You can attach files in this forum You can download files in this forum
|
|
|