View previous topic :: View next topic |
Author |
Message |
U2U2U2
Joined: 06 Jul 2001 Posts: 5467 Location: Shipsterns Bluff, Tasmania. Colorado
|
Posted: Sat Jun 15, 2019 10:07 am Post subject: |
|
|
erniej wrote: | option B (epoxy, then drill a slightly smaller hole, with a 9/64" bit, and then self-tap with the original slot box screw) worked for me. The screw started gripping again. I'll be less forceful when tightening slot box screws next time (I already learned the lesson the hard way with US Box fin screws). Important was to tape the other side of the hole shut so the epoxy stays put until hardened, and to tilt the board so the epoxy dried flush with the top of the hole. Also, epoxies I tried other than West System 105 resin with 205 hardener were too soft when cured and drilling ripped the glue out. West System epoxy drilled out nicely with a fine dust flowing out the bottom hole. |
Pleased to read it worked. _________________ K4 fins
4Boards....May the fours be with you
http://www.k4fins.com/fins.html
http://4boards.co.uk/ |
|
Back to top |
|
|
|
|
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum You can attach files in this forum You can download files in this forum
|
|
|