View previous topic :: View next topic |
Author |
Message |
grantcantsail
Joined: 09 Sep 2013 Posts: 12
|
Posted: Mon Sep 09, 2013 12:39 pm Post subject: Problem with sheeting in after the sail flip |
|
|
Assuming Ive actually managed to get thru the jibe planing (never a problem on my usual poor not planing exits) I have this ongoing problem where after the flip I try and sheet in and..... aaaagh..... go in to windward. Im guessing Im not turning enough but my head sort of hurts thinking about it. I think I read somewhere the mast is on the wrong side of the board (for sure its slightly to windward) but Im not sure what to do with that observation. |
|
Back to top |
|
|
isobars
Joined: 12 Dec 1999 Posts: 20935
|
Posted: Mon Sep 09, 2013 12:49 pm Post subject: |
|
|
You have entered too slow (likely), slowed down too much (HIGHLY likely), turned too far back upwind (less likely at your carve rate unless you're deliberately waiting for the wind to jibe the sail for you), and/or waited far too long to jibe the sail. Improve all those -- enter faster, spend less time and space running downwind, jibe your sail yourself forcefully rather than waiting for the wind to do it for you, jibe your sail sooner, sheet in and accelerate by the time your board barely passes dead downwind -- and your planing exit rate should increase very quickly.
Last edited by isobars on Tue Sep 10, 2013 7:29 pm; edited 1 time in total |
|
Back to top |
|
|
Wind-NC.com
Joined: 30 May 2007 Posts: 980 Location: Formerly Cape Hatteras, now Burlington, VT!
|
Posted: Mon Sep 09, 2013 2:19 pm Post subject: |
|
|
Hi Grant- if the sail is "slicing" into the wind without any power, you need to simply grab the new side of the boom further back. Aim for getting your front hand as close to the harness lines as you can get it, and your back hand way back towards the tail of the boom. That way if you only get halfway there, you're still in a pretty decent position _________________ formerly known as hodad.andy
http://wind-nc.com |
|
Back to top |
|
|
keycocker
Joined: 10 Jul 2005 Posts: 3598
|
Posted: Mon Sep 09, 2013 3:21 pm Post subject: |
|
|
many folks fail to continue the foot work through the jibe so the turn comes up short.
Another possibilty.is that you are not leaning the sail sharply forward after the turn. This will bring the boom within reach.
This is often not mentioned because not everyone needs to do it and most others don't think of it as a distinct move , they just do it. |
|
Back to top |
|
|
isobars
Joined: 12 Dec 1999 Posts: 20935
|
Posted: Mon Sep 09, 2013 5:52 pm Post subject: |
|
|
Whoops! Save my answer above for when you start getting tossed leeward or over the nose exiting a jibe. Are you saying you're exiting planing with your feet already switched but have not yet jibed the sail, then fall backwards/upwind when trying to jibe it? Then you're REALLY jibing the sail FAR too late, unless you are baaaaaaaarely powered enough to juuuuuust plane in the gusts on a broad reach. If that's the case, you may have no choice but to milk the sail for power the way through, then very forcefully spin the sail when you get a gust later on. Once you get better at spinning the sail (Throw, Throw, Grab, and Go) about its own axis, you can do that at the moment your sail loses power at mid-jibe, then exit sheeted in on the new broad reach.
Of course, this presumes you're on something under a 7.5. Is that the case?
Mike \m/ |
|
Back to top |
|
|
grantcantsail
Joined: 09 Sep 2013 Posts: 12
|
Posted: Tue Sep 10, 2013 8:03 am Post subject: |
|
|
It really only happens when Im for sure exiting the jibe with speed (I have plenty of cases with no speed to compare it to:)). Can almost predict its going to happen now. I think the mast is over on the "new" side of the board (maybe too far?) and I'm sort of focused on reaching back on the boom to overcome the problem but no dice. Ive also switched my feet by now. The rig absolutely DRIVES DOWN into the water and just takes me with it. Maybe Im bit back on the board with the sail in these cases though as I have a general problem keeping forward in the turn but in these cases speed is up pretty good for me. So anyway thats the symptom I need a cure. |
|
Back to top |
|
|
grantcantsail
Joined: 09 Sep 2013 Posts: 12
|
Posted: Tue Sep 10, 2013 8:10 am Post subject: |
|
|
Yup -its usually powered up a cambered 5.3 that rotates easily on a 100l slalom board. My jibes for sure take too long at this point but it is what it is. This normally happens on what I would consider a solid entry and carve. |
|
Back to top |
|
|
techno900
Joined: 28 Mar 2001 Posts: 4164
|
Posted: Tue Sep 10, 2013 8:34 am Post subject: |
|
|
Quote: | The rig absolutely DRIVES DOWN into the water and just takes me with it |
Windward side or leeward side of the board? |
|
Back to top |
|
|
outhaul
Joined: 27 Sep 2011 Posts: 254
|
Posted: Tue Sep 10, 2013 8:55 am Post subject: |
|
|
Hodadandy said:
Hi Grant- if the sail is "slicing" into the wind without any power, you need to simply grab the new side of the boom further back. Aim for getting your front hand as close to the harness lines as you can get it, and your back hand way back towards the tail of the boom. That way if you only get halfway there, you're still in a pretty decent position
This is a fantastic tip, it really works! |
|
Back to top |
|
|
dhmark
Joined: 04 Sep 2007 Posts: 376
|
Posted: Tue Sep 10, 2013 4:41 pm Post subject: |
|
|
It sounds like initiating the sail flip too late. When you do a good entry and carve, a fair proportion of the turn occurs during the sail flip, and then it comes to you at the right time. Of course, like me, it is unpredictable when the smooth fast carve will happen. Flipping early on a stalled carve leaves you hanging on to luffed sail, then fall. Dhmark |
|
Back to top |
|
|
|
|
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum You can attach files in this forum You can download files in this forum
|
|
|